Where is the reset button located on a furnace?
blower compartment
All furnaces are equipped with a reset button. They are generally red or yellow and are located inside the blower compartment. The reset button is a safety feature that will shut down the furnace when a problem is detected, often a hot or overheating furnace, before it trips the circuit breaker.
How to reset a furnace using the furnace reset button?
If the furnace doesn’t have a power switch you can turn off, turn off the circuit breaker controlling the furnace, open the blower housing and locate the reset button on the side of the blower motor. Press it in until it clicks and then restore power to the furnace by turning the breaker back on.
Is there a reset button on the furnace blower motor?
Most electric motors, including the furnace blower motor, have a reset switch that pops up when this happens. Often the problem corrects itself and it is only a matter of pressing the reset button to get the furnace going again.
Why does my furnace reset when it gets too hot?
By Kenneth Crawford. When the motor on your furnace gets too hot or there is an interruption within the electrical system, a switch will trip causing the furnace to shut down usually before the circuit breaker trips. Most electric motors, including the furnace blower motor, have a reset switch that pops up when this happens.
Where is the rest button on a furnace?
Lightly touch the motor housing with your fingers. If the housing is hot, allow the motor to cool before looking for and resetting the rest button. Look for a small red or yellow button on the side of the blower motor. If you do not see one on the side of the motor that is facing you, feel around to the back of the motor housing for the button.
How do you restart a furnace?
Restarting the furnace can be as simple as pushing the red reset button on your furnace. You may need to press the reset button several times to bleed the fuel line and restart your furnace. Once the heater has turned on, your home will be heated normally.
What does the reset button on a furnace do?
A furnace reset button is connected to a sensor that monitors the flame of your burner. When the flame goes out, the reset button is tripped and the system shuts down to prevent damage.
How do you reset a carrier furnace?
Leave the furnace’s pilot gas supply line on. Light a match. Hold it at the opening of the pilot flame jet that is inside the furnace to re-light the pilot flame. Turn the power back on and then the main gas supply. Locate the reset button. It is labeled, sometimes in red. Press and hold the reset button for 30 seconds.
