What is the main board assembly for WFCO wf-8900 series?
WFCO MAIN BOARD ASSEMBLY FOR WF-8900 SERIES CONVERTERSReplaces the lower power converter section on WF-8900 Series converters. Installs easily with only 4 screws and five wires. 15501 Main Board Assembly is 35 Amp DC.
How can I find out my WFCO 8935 model number?
When trying to determine your model number, you might find the label that says, WFCO 8935/45/55. That is a generic label they used on all three models. It is most likely a 55 but if you are not sure, look on the panel next to the circuit breakers on the label marked “Electrical Ratings” See the link below to determine your model.
How many amps does a wf-8955 power center have?
The WF-8900 Series has revolutionized RV power centers with its lighter weight, decorative doors and superior features. The WF-8955 model provides 55 Amps and a clean, constant 13.6 VDC nominal output, for reliable operation of electronics and appliances.
What’s the difference between WFCO 8955 ANP and PEC?
WFCO 8955 AN (P) and PEC Replacement Converters Most of the WFCO 8900 series converters are the 8955 ANP or the newer PEC. There are a few 35 and 45 Amp units out there but they are the same physical size and we recommend the 55 amp model regardless which brand you choose.
How many amps does a wf-8935 power center have?
The WF-8900 Series has revolutionized RV power centers with its lighter weight, decorative doors and superior features. The WF-8935 model provides 35 Amps and a clean, constant 13.6 VDC nominal output, for reliable operation of electronics and appliances.
Is the WFCO wf-8935 MBA main board assembly?
It was, of course, a 110v system. However, the original WFCO voltage converter/ breaker and fuse panel protected all the appliances and generator exceptionally well. The voltage converter and TV were toast but everything else , including the house batteries and all the outlets were spared.
How to install a wf-8935an battery box?
Models WF-8935AN W/PLASTIC, WF-8945AN W/PLASTIC W/PLASTIC, WF-8955AN INSTALLATION INSTRUCTION 1 Mounting: Select the mounting location near the shore power inlet and batteries and cut a rough opening 1/8″ wider than the box to allow the Distribution panel to slide in easily. The hole should be framed so that the box can be secured tightly.
Is the original WFCO breaker and fuse panel still working?
However, the original WFCO voltage converter/ breaker and fuse panel protected all the appliances and generator exceptionally well. The voltage converter and TV were toast but everything else , including the house batteries and all the outlets were spared. I replaced the WFCO converter with this new unit and everything worked as new.
