What can I do to fix my landing gear?
(1) Removal, installation, and repair of landing gear tires. (2) Replacing elastic shock absorber cords on landing gear. (3) Servicing landing gear shock struts by adding oil, air, or both. (4) Servicing landing gear wheel bearings, such as cleaning and greasing.
How do you remove motor from fifth wheel landing gear?
2. Remove plastic retainer that secures gearbox onto drive shaft so motor assembly can be removed from leg. A small screw holds this in place. 3. Slide gearbox with motor attached off the drive shaft, moving the shaft to opposite leg aside as necessary. The manual override drive shaft attached to the gearbox will easily slide out of its housing.
Which is the best landing gear change device?
They stand out with highest operating convenience and cost efficiency. We offer a wide range of different Main Landing Gear Trolley (MLGT). The MLGT is a one-base device to replace the main landing gears without wheels and brakes of various narrow body aircrafts.
What does mlgt stand for in landing gear change?
The MLGT is a one-base device to replace the main landing gears without wheels and brakes of various narrow body aircrafts. Our Nose Landing Gear removal / installation trolley (NLGT) has been specially designed for landing gear maintenance changes.
(1) Removal, installation, and repair of landing gear tires. (2) Replacing elastic shock absorber cords on landing gear. (3) Servicing landing gear shock struts by adding oil, air, or both. (4) Servicing landing gear wheel bearings, such as cleaning and greasing.
Why is my fifth wheel landing gear not working?
As it turns out though the part had a slight difference. The crescent-shaped opening for the landing leg gear shaft was slightly smaller, making it impossible to attach to the landing leg drive shaft. I got around this by swapping out the main gear from my original gearbox into the new one and made it work.
How to change the landing gear on a Lippert?
Make sure it is oriented correctly regarding the bulged-out side of the leg, as shown in the diagram, and that you are inserting the shaft from the bulged-out side. Hold the gear against bushing, moving it around as you push on the drive shaft until things line up and shaft goes into and through gear.
What to do about broken fifth wheel landing leg?
I surmised that a small metal pin needed to be punched out to get the ball rolling sort of speak. Sure enough, once I punched out the pin on the top beveled gear and another below the larger lower beveled gear, the rest of the mechanism could be easily taken apart exposing the long worm gear.
