How much does it cost to replace a rear pinion seal?
The average cost for pinion seal replacement is between $229 and $276. Labor costs are estimated between $170 and $214 while parts are priced between $60 and $62. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
When to replace rear axle bearings and seals?
After the axle has been removed inspect the bearing and seal surface to check for wear and scoring and replace if damaged. If this axle is worn you will see an obvious groove in this area. Do not reuse the axle at this point because the new seal and bearing will fail prematurely.
Can a rear differential pinion seal be replaced?
I purchased a seal that was for my truck but once i got my seal out it turned out my truck did not have the standard 1/2 axle in it. It seems to be that it has been swapped out for a 1 ton limited slip rear end. it’s been a week after doing the project and all seems to be good there isn’t any leaks at all what so ever. Loading…
How many differential bearing pullers are left in stock?
Only 4 left in stock (more on the way). . Only 10 left in stock (more on the way). . Only 17 left in stock – order soon. . . Temporarily out of stock. . Only 7 left in stock – order soon. . Only 5 left in stock – order soon. . Only 2 left in stock (more on the way). . Only 12 left in stock – order soon.
How do you remove rear axle from differential?
Using a small screwdriver or magnet work the metal “C” clip in a circular motion, This will enable you to remove the clip which will release the axle from the differential. This can take a little time so hang in there.
How to remove rear axle bearing and seal?
Doing just the seals is much easier. Just pop the old one out, then light tap in a circle around the outer part of the seal until its seated. You’ll have to remove the diff cover and take off the C-clip that holds the axle in place, then slide out the axle.
Where can I buy a wheel bearing seal puller?
Powerbuilt 10 Pc. Bearing And Race Installer Kit – 948004 . . . Only 12 left in stock – order soon. . . Only 7 left in stock – order soon.
Using a small screwdriver or magnet work the metal “C” clip in a circular motion, This will enable you to remove the clip which will release the axle from the differential. This can take a little time so hang in there.
How much does it cost to replace rear axle seal?
If this axle is worn you will see an obvious groove in this area. Do not reuse the axle at this point because the new seal and bearing will fail prematurely. These axles are available at the dealer for about $200.00 bucks. Now we are ready to remove the seal.
