How do I use my Atwood RV furnace?
How do you use Atwood Hydro Flame Furnace?
- Charge your RV’s battery up and turn the Atwood Hydro-Flame furnace’s gas valve on to the “pilot” position.
- Light a match while pushing and holding the gas valve.
- Allow the gas flame to burn for a moment before switching the gas valve over to the “on” position.
Why Is My RV furnace running but no heat?
If the fan on your RV furnace does not run and there is no heat, check the battery with a battery tester. If the battery is putting out at least 12 volts, then the battery is fine. The problem could also be a blown fuse on the fan. Replacing the fuse should get the fan running again.
What is Hydro Flame furnace?
The Hydro Flame RV Furnace is one of the first units you’ll encounter in your search. This is a lightweight, compact model, weighing in at just 23 pounds with dimensions of 11-3/8″ high, 8-3/8″ wide, and 20-1/2″ deep.
Where is the flame sensor on an Atwood RV furnace?
It’s located on the burner assembly and is just a thin metallic rod. It’s usually bent, and it sits just in front of the pilot flame inside the furnace.
How do I reset my Dometic RV furnace?
How do I Reset My Dometic Furnace? Generally, this is a very simple process. All you have to do is turn the power off for a couple of minutes so the thermostat has time to reset itself. Then you just turn it back on and your furnace lockout should be reset and everything should be working like normal.
How do you start a Hydro flame Furnace?
Charge your RV’s battery up and turn the Atwood Hydro-Flame furnace’s gas valve on to the “pilot” position. Light a match while pushing and holding the gas valve. Hold the match over the pilot to light it. Allow the gas flame to burn for a moment before switching the gas valve over to the “on” position.
When did the Atwood furnace service manual come out?
The 2004 edition of the Atwood Furnace Service Manual is a resource created to help service technicians identify Atwood product by serial number, diagnose service problems and efficiently and effectively process warranty claims. Changes to the Hydro Flame furnaces include:
What kind of igniter board do I need for Atwood furnace?
* Please Note: You may add the OEM igniter board 31501 or after-market igniter board DPFAN50PLUS, the gas valve option and the blower motor options from the option box above.*
Where can I get Atwood RV Repair Service?
Service for all Atwood products is handled out of our Rockford location. Should you have any questions regarding our products or the information contained in this manual simply dial 1-800-825-4328. Be sure to have the Model and Serial Number when you call.
Who is required to install an Atwood hydro flame?
Installation and service must be performed by a qualified Service Technician, Service Center or gas supplier. THIS INSTRUCTION MANUAL IS FOR USE BY AN AUTHORIZED SERVICE TECHNICIAN TO INSTALL AN ATWOOD- hydro flameTMFURNACE. TO THE INSTALLER: THESE INSTRUCTIONS MUST BE SUPPLIED WITH THE FUR- NACE TO THE CONSUMER.
