Disconnect the electrical power. Unplug the freezer or shut off the circuit breaker for the freezer.Remove the control knob. … Remove the grille cover. … Remove the cold control thermostat. … Install the new cold control thermostat. … Reinstall the grille cover. … Reinstall the control knob. … Restore electrical power.

Where is the thermostat on a Kenmore freezer?

Located on the back wall of the freezer section in the refrigerator, the defrost thermostat is used to regulate the appliances temperature to keep the refrigerator cold and constant. The part is made of plastic, and has a 4 inch terminal on the white lead and a 6 inch terminal on the red lead.

Where is my thermostat on my freezer?

In freezer-on-top models, it may be located under the floor of the unit, or it could be found at the back of the freezer. If you have a side-by-side refrigerator, the defrost thermostat is found at the back of the freezer side.

How do I know if my freezer thermostat is bad?

If food freezes inside the fridge or its compartments, the cause may be a faulty thermostat. You can use an appliance thermometer to check the thermostat, or try increasing the temperature a couple of degrees. Then wait a day to check whether the food has become unfrozen.

Where is temperature control on Kenmore upright freezer?

On older upright freezer models, the temperature control is usually located in the middle of the rear wall of the interior cabinet liner. On newer upright freezer models, the temperature control is usually located on the exterior front of the unit on the door.

Why is my Kenmore freezer not freezing?

The freezer in a Kenmore freezer may not keep food frozen for numerous reasons such as frozen evaporator coils, leaky refrigerator hoses, a too-crowded freezer, a clogged defrost drain or a malfunctioning or broken thermostat.

How do I reset my Kenmore freezer?

Another way you can reset certain Kenmore freezers is by pressing and holding the UP arrow button until the display finally starts showing 10 digits on the display. You will then need to press the Alarm reset button.

What happens when a defrost thermostat goes bad?

Defrost Thermostat Specifications. … A faulty defrost termination thermostat may result in the defrost heater never heating and a solid frost buildup on the evaporator coil, which results in too warm temperatures. The thermostat contacts are normally closed and have continuity until it reaches 140 degrees.

How do you change a thermostat in a freezer?

  1. Disconnect the electrical power. Unplug the freezer or shut off the circuit breaker for the freezer.
  2. Remove the control knob. …
  3. Remove the grille cover. …
  4. Remove the cold control thermostat. …
  5. Install the new cold control thermostat. …
  6. Reinstall the grille cover. …
  7. Reinstall the control knob. …
  8. Restore electrical power.
Do fridge freezers have two thermostats?

There are two thermostats, one for the refrigerator, one for the freezer. Both are pressure bulbs (older units) and/or temperature sensors (newer units). Here’s how it works. The thermostat for the freezer controls the power going to the compressor.

Article first time published on

What is the coldest setting on a Kenmore freezer?

The warmest setting is 1 and the most cold is 7. The freezer should be set for 4. This equates to zero degrees.

What temp should a upright freezer be set at?

Keep your appliances at the proper temperatures. Keep the refrigerator temperature at or below 40° F (4° C). The freezer temperature should be 0° F (-18° C).

What number should freezer be set at?

The recommended freezer temperature to keep your food safe is at or below 0°F (-18°C), but your freezer may need to be set higher or lower depending on its environment and other factors. The typical freezer factory setting on Whirlpool® refrigerators is a great starting point at the recommended 0°F (-18°C).

Why is my freezer cold but not freezing?

Causes: If your freezer won’t freeze, most likely the condenser coils are dirty which reduces the overall cooling capacity of the freezer. Evaporator fan motor is malfunctioning, and since it’s in charge of circulating the air throughout the freezer, this will need to be resolved, pronto.

Where is the reset button on Kenmore ice maker?

The reset button is either on the bottom left of the ice maker, or it is located on the front left panel as a tiny hole. If it has the tiny hole reset, you’ll need a paper clip to push the button. Press and hold the button for three seconds.

How does a freezer thermostat work?

The thermostat controls the cooling process by monitoring the temperature and then switching the compressor on and off. When the sensor senses that it’s cold enough inside a refrigerator, it turns off the compressor. If it senses too much heat, it switches the compressor on and begins the cooling process again.

Does the fridge thermostat control the freezer?

This control does not actually control the cold—it controls the air that circulates between the freezer and the refrigerator. Fortunately, most manufacturers label the two controls with a suggested normal setting. With a new refrigerator, the recommended settings are the place to start.

How do I reset my freezer compressor?

  1. Step 1: Move the Refrigerator out from the Wall. …
  2. Step 2: Unplug the Refrigerator. …
  3. Step 3: Shut off the Control Panel. …
  4. Step 4: Plug the Refrigerator Back In. …
  5. Step 5: Reset the Temperature Settings. …
  6. Step 6: Move Your Refrigerator Back into Place. …
  7. Step 7: Wait at Least 24 Hours.

How do you install a thermostat in a deep freezer?

  1. Step 1: Replace the Thermostat. …
  2. Step 2: Remove the Panels. …
  3. Step 3: Remove the Screws or Retaining Clips. …
  4. Step 4: Locate the Two Wires and Remove the Thermostat. …
  5. Step 5: Install the New Thermostat. …
  6. Step 6: Reassemble the Freezer.

How much is a thermostat for a freezer?

This item Refrigerator or Freezer Thermostat (Temperature Controller)Rubbermaid FGR80DC Refrigerator Freezer Cooler Fridge Thermometer, Classic Large Mechanical Dial, ChromePrice$6931$947Sold ByHome Brew OhioAmazon.comColorMultipleChrome

Where is the fridge thermostat?

Thermostats are typically found inside the refrigerator and have a knob that allows users to adjust the temperature setting. Once a user sets the desired temperature, the thermostat maintains that temperature by controlling the flow of electricity to the compressor.

Can you fix a fridge thermostat?

You can replace a fridge thermostat in a few minutes with some basic hand tools, and the cost is minimal when compared to a service call to a technician or a new refrigerator.

Why is my freezer not defrosting?

If the defrost sensor fails to shut off the defrost heater, the fuse will blow in order to shut off the defrost heater. If the defrost sensor fuse blows, the defrost system will not work, and the refrigerator will not defrost. … If either the defrost sensor or fuse does not have continuity, replace the defrost sensor.

Where is the defrost timer located on a Kenmore refrigerator?

The defrost timer is located in the control housing which is in the refrigerator section of your appliance.

Can I replace thermostat myself?

Can I do it myself? An experienced DIY-er can install most programmable thermostats and some smart thermostats. … If you’re replacing a central air conditioner or heating system, consider a thermostat upgrade at the same time – find a unit that will work with your family’s habits to save you the most.

Can I replace my thermostat with any thermostat?

Purchase a replacement thermostat that will work with your system. … Most replacement thermostats are compatible with all common systems. However, if your system is unique, finding a replacement thermostat may be difficult.

Is it easy to replace a thermostat?

Upgrading to a thermostat that automatically changes the indoor temperature setting is fairly easy, and it can trim about $180 off your annual heating and cooling costs, according to the EPA. Simple models that only control heat are sold at home centers for around $25.

How do I test my cold control thermostat?

Set your multitester to the R X 1 ohms setting. Place each of the multitester’s leads on a thermostat wire. When your thermostat is cold, it should produce a reading of zero on your multitester. If it is warm (anywhere from forty to ninety degrees Fahrenheit), then this test should produce a reading of infinity.

What does the orange light on my freezer mean?

If there is an orange light on the refrigerator or freezer, it means that the ambient temperature is too high or too low. Correct operation can only be guaranteed for products that are within the ambient temperature range of 10 C-32 C.

Is a freezer colder at 1 or 5?

On every fridge the rules for the coldest settings are always the following: The numbers on the fridge’s temperature dial indicate refrigerant power. The higher the number goes the colder the fridge will maintain. Setting it to 5 will make your fridge the coldest.

Is 1 or 7 colder on a freezer?

Your freezer will automatically maintain the temperature level you select. … “1” is the warmest, “7” is the coldest, and turning the temperature dial to OFF shuts down the compressor. Set the dial to “4” and allow 24 hours to pass before adjusting the temperature to your needs.