How do I adjust the choke on my generator?

Next: Turning On Your Generator

  1. Turn fuel valve on. Flip the fuel valve on.
  2. Turn choke on. Move the choke rod from right to left.
  3. Turn ignition (or engine switch) on. Many generators require you to flip the switch to turn the engine on.
  4. Pull recoil cord.
  5. After the engine starts, move engine choke to “run”

Where should the choke be on generator?

The choke of any engine should be set to “closed” during startups and then moved to “open” once the engine warms up. Depending on the style of your generator, this choke lever may be positioned in a few different places. On many generators, it can be found directly above the air filter on the side of the unit.

What causes a generator to shut down after a few seconds?

With low oil levels, you can start your generator but after a few seconds, the temperature of the oil rises too quickly and it causes the system to shut down. When the oil level is too high, it also causes the sensor to force a shutdown. Mostly generators with low oil level auto shut-down feature turn your generator off.

What to do if your Onan generator starts then shuts down?

If there is no AC, proceed to check the field flash voltage through the field flash pin of the board. In the case field flash voltage is not present, the control board may be defective. If that happens to be the case, the “Onan generator starts then shuts down” issue could be taken care of by replacing the unit control board.

What should I do if my generator wont start up?

The generator might be able to power the operating load, but not the start-up load which could be anywhere up to five times higher. Solve the problem by removing some of the items temporarily. Add them gradually, waiting for one to settle into operating mode before adding another. 5. Replace Fuses and Circuit Breakers

What happens when the oil level in a generator is too low?

With low oil levels, you can start your generator but after a few seconds, the temperature of the oil rises too quickly and it causes the system to shut down. When the oil level is too high, it also causes the sensor to force a shutdown.